8.10. Remove the Stand bracket and
the Hanger metals
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Unlock the cable clampers to free the cable.
3. Remove the AC inlet. (See section 8.2.)
4. Remove the Stand bracket fastening screws (×5
remove the Stand bracket.
5. Remove the Hanger metals (L, R) fastening screws (×2
each) and remove the Hanger metals (L, R).
8.11. Remove the Radiator plate
1. Remove the Stand bracket and the Hanger metals. (See
section 8.10.)
2. Remove the screws (×15
plate.
) and
) and remove the Radiator
8.12. Remove the C1-Board
1. Remove the Stand bracket and the Hanger metal R. (See
section 8.10.)
2. Disconnect the flexible cables (CB1, CB2, CB3, CB4,
CB5, CB6 and CB7).
3. Disconnect the flexible cables (C10 and C11).
4. Remove the screws (×4
8.13. Remove the C2-Board
1. Remove the Stand bracket and the Hanger metal L. (See
section 8.10.)
2. Disconnect the flexible cables (CB8, CB9, CB10, CB11,
CB12, CB13, CB14 and CB15).
3. Disconnect the flexible cables (C20, C21 and C23).
4. Disconnect the connector (C25).
5. Remove the screws (×4
23
) and remove the C1-Board.
) and remove the C2-Board.