Wireless Connection Configuration - AEG T8DHC876C User Manual

6.2 Wireless connection configuration

Before you begin configuration download and install AEG Home
application on your smart device.
1. Push the On/Off button to switch on the appliance.
2. Wait approximately 8 seconds.
3. Touch and hold the Refresh and Delay Start buttons
simultaneously for a few seconds until a 'click' sound is heard.
The symbols:
remains only flashing symbol:
around 1 minute. When ready the symbol:
appears on the display. Access Point is open around 3 minutes.
4. Configure AEG Home application on your smart device.
If the configuration is successful the symbol:
disappears and the symbol:
Each time you switch the appliance on, the appliance attempt to
connect to the network automatically. When the connection is
established the symbol:
To switch off the wireless connection , touch and hold down
Refresh and Delay Start buttons at the same time for 3
seconds. The symbol:
Appliance stores last connection configuration. To use wireless
features of the appliance the wireless connection must be in
mode.
To remove the wireless credentials, touch and hold down
Refresh and Delay Start buttons at the same time for 10 seconds.
The symbol:
WI-FI - CONNECTIVITY SETUP
and appear on the display. After few seconds
stops flashing.
stops flashing.
appears on the display.
appears on the display.
. Wireless module is activating
(Access Point)
(Access Point)
19/64