GigaTent MM01 Owner's Manual

Mini Explorer Dome
MM01
Mini
Command Dome
MM02
STEP 1:
Confirm product contents by emptying contents of bag(s)
and confirming all parts are included and undamaged.
STEP 2:
Select a smooth level site and spread out your tent.
STEP 3:
Extend poles and place in position ready for installation.
Take a tent pole and push it through a pole sleeve located
at the top of tent. Repeat process with the remaining tent
pole. Poles will cross each other at the center (Figure A).
STEP 4:
After sliding poles through sleeves, insert bottom of pole into
pin at bottom of tent. Repeat process on corners of the tent
(Figure B).
NOTE: Make sure pole sleeve fabric is evenly distributed
along pole and does not catch at pole joints. Undue stress
could break pole or tear fabric.
STEP 5:
Tie the straps onto the poles atop of tent (Figure C).
STEP 5:
Insert short pole into the bottom of fly to make the
awning, depending on model.
STEP 7:
Attach hooks on corners of fly to the rings located on the bottom
corners of tent. The tent is now fully assembled.
DESCRIPTION QTY.
DOME TENT
100% Polyester 1
POLES
Fiberglass Pole; Black 3
CARRY POUCH
100% Polyester 1
DESCRIPTION QTY.
DOME TENT
100% Polyester 1
FLY
100% Polyester 1
POLES
Fiberglass Pole; Black 3
CARRY POUCH
100% Polyester 1

ASSEMBLY INSTRUCTIONS

Owner's Manual
MODEL # MM01 / Mini Explorer Dome
Tent= 15" x 15" x 12"
MODEL # MM02 / Mini Command Dome
Tent= 15" x 15" x 12"
A
C
B