Table of Contents
Advertisement
Mount the front panel to the switches on the PC
board, using four #4 screws or 4-40 x 1/4" screws
and four 4-40 nuts, see Figure K.
Remove the colored boots from the four alligator
clips (to remove the boots, clip the alligator clip onto
a pencil and slide the boot off). Slide each boot onto
the four corresponding colored wires (black boot
onto black wire, etc.).
Solder an alligator clip to each wire as shown in
Figure L. Slide the boots back onto the clips.
Turn the shaft of the base current control fully
counter-clockwise.
knob with "0" on the front panel, see Figure M. Push
the knob onto the shaft.
Cut two 2" pieces of double sided tape, peel off the
protective backing on one side and place next to
each other on the inside bottom of the case in the
position shown in Figure N.
Obtain a 9 volt battery (alkaline preferred). Remove
the backing on the tape and mount the battery onto
the tape, as shown in Figure N.
Press the battery snap onto the battery terminals.
Mount the assembled panel into the case, using four
self-tapping screws.
Your transistor/diode tester is now completed and
ready for testing.
Align the marker line on the
Bend tabs over wire
Boot
Figure M
Figure N
-6-
Figure K
No. 4
Screws
Panel
PCB
4-40x1/4"
Screws
Panel
4-40 Nut
PCB
Figure L
Clip
Tape
9V
Advertisement
Table of Contents
