Section 5 - Assembly Instructions - Elenco Electronics AK-200 Assembly And Instruction Manual

SECTION 5 - ASSEMBLY INSTRUCTIONS

TOOLS NEEDED: Small Blade Screwdriver, Phillips Screwdriver (small point size), Diagonal Cutters, Long
Nose Pliers and a Soldering Iron (25 - 40 watts).
PC BOARD ASSEMBLY - Your kit may contain several extra capacitors and wires. Please disregard these parts.
Identify and install the following parts as shown in Figure 5-1. After soldering each part, place a check in the
box provided.
C6 - .001mF (102) Capacitor
(Lay flat on board)
C5 - .001mF (102) Capacitor
(Lay flat on board)
C3 - 10mF Lytic Capacitor
(see Figure C)
R1 - 390W 5% 1/4W Resistor
(orange-white-brown-gold)
C1 - .02mF (203) Capacitor
R3 - 12kW 5% 1/4W Resistor
(brown-red-orange-gold)
R4 - 180kW 5% 1/4W Resistor
(brown-gray-yellow-gold)
C7 - Jumper Wire
(see Figure A)
C20 - .005mF (502) Capacitor
(This location may not be marked
on the PC board. Use the picture.)
C8 - This is not used.
VR2 - 1kW Potentiometer
(see Figure B)
R7 - 1kW 5% 1/4W Resistor
(brown-black-red-gold)
8-pin IC Socket
IC2 - AN6650 Integrated Circuit
(see Figure D)
C16 - .001mF (102) Capacitor
C17 - .1mF (104) Capacitor
R8 - 8.2kW 5% 1/4W Resistor
(gray-red-red-gold)
C11 - 220mF Lytic Capacitor
(see Figure C)
Jumper Wire (see Figure A)
C12 - 100mF Lytic Capacitor
(see Figure C)
Figure A
Use a discarded resistor lead
for a jumper wire.
Figure 5-1
These capacitors are polarized.
Be sure to mount them with the
"+" lead in the correct hole as
marked on the PC board. Mount
the capacitor lying flat on the PC
board as shown below.
-6-
Figure B
Figure C
(–) (+)