Section 8 - Final Assembly - Elenco Electronics AK-200 Assembly And Instruction Manual

SECTION 8 - FINAL ASSEMBLY

Place the tape deck on the bottom plate. Be sure
that the wires to the PC board do not touch the
pulleys or drive belts and will not interfere with
the batteries. Snap on the top plate and fasten
with two 1" screws as shown in Figure 8-1.
If not already in place, snap the lid onto the
bottom plate as shown in Figure 8-1.
Bottom Plate
Lid
Top Plate
"AA" Batteries
Battery Cover
Place the clip over the three mounting holes in
the top plate as shown in Figure 8-2. Press down
to snap the clip onto the top plate.
Put two "AA" size batteries (alkaline works best)
into the AK-200. The polarity is shown on the
case. Then, slide the battery cover in place as
shown in Figure 8-2.
Figure 8-1
Figure 8-2
-12-
1" Screws
Top Plate
Tape Deck
Clip