Table of Contents
Advertisement
QS600T
6"Two Way Full Range Pro Speaker System
Technical Sheet
System:
Tweeter:
Woofer
Frequency response(-3dB):
Sensitivity(1W@1m):
Max.SPL(1m):
Power:
Dispersion(H¡ Á V):
Rated impedance:
Crossover point:
Cabinet:
Mounting
accessories:
Painting:
Connector:
Cabinet dimension:
(W x H x H)
Package dimension:
(W x H x H)
N.W.(2pcs):
G.W.(2pcs):
Frequency Response And Impedance Curve
100
90
80
70
60
50
20
50
6
Two way full range speaker
2 3 High frequency drivers
"
:
1 6 Woofer
"
1
80Hz-16kHz
2
88dB
3
114dB/120dB(PEAK)
4
80W (RMS)
160W (MUSIC)
320W (PEAK )
140° x 160°
8 Ohms
2.5 kHz
Polypropylene injection moulding
3 M8 Bracket lifting point
Cabinet Exterior with/without
polyurethane spraying treatment
(depends on colors)Grill with cloth
Wire clamp
399mm 241mm 229mm
(15.7in 9.5in 9in)
452mm 310mm 525mm
(17.8in 12.2in 20.1in)
9kg(19.8 lb.)
10kg(22 lb.)
Frequency response curve
Impedance curve
100
200
Speaker Testing Method
1. Frequency response
Use Pink noise to test the speaker in the anechoic room,
adjust the level to make the speaker work at its rated
impedance and the power output is 1W, then test the
frequency response 1m away from the speaker.
2. Sensitivity
Use full range Pink noise which was modified by EQ curve
to test the speaker in the anechoic room, enlarge the signal
to make the speaker work at its rated impedance and the
power output is 1W, then test the sensitivity 1m away from
the speaker.
3. MAX.SPL
Use full range Pink noise which was modified by EQ curve
to test the speaker in the anechoic room, enlarge the signal
to make the speaker work at its instant power output level,
then test the SPL 1m away from the speaker.
4. Rated Power
Use the pink noise according to IEC#268-5 to test the speaker,
enlarge the signal for continuous 100hours, the rated Power
is the power when the speaker will not incur hot damage or
mechanics damage.
500
1k
2k
Frequency (Hz)
TECHNICAL SPECIFICATION
5k
10k
50
30
20
13
8
5
20k
Advertisement
Table of Contents
