1. Manuals
  2. Brands
  3. Erskine Attachments Manuals
  4. Industrial Equipment
  5. V-Plow
  6. Operator's manual

Erskine Attachments V-Plow Operator's Manual

Skid steer loaders
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
V-Plow
For
Skid Steer Loaders
Operator's Manual
Maintenance
Parts Information
Read this Manual Before Use

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the V-Plow and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Erskine Attachments V-Plow

Summary of Contents for Erskine Attachments V-Plow

  • Page 1 V-Plow Skid Steer Loaders Operator’s Manual Maintenance Parts Information Read this Manual Before Use...

  • Page 2: Table Of Contents

    Serial Number………….._____________ YOUR ATTACHMENT DEALER ADDRESS: PHONE: CONTACT: NOTE: Erskine Attachments LLC reserves the right to make improvements in design or changes in specifications at any time without notice and without incurring any obligations to install them on units previously sold.

  • Page 3: Safety

    Indicates potentially Erskine Attachments LLC cannot anticipate every hazardous situation which, if not avoided, possible circumstance that might involve potential will result in death or serious injury. hazard. The safety messages found in this manual ...
  • Page 4 • Do not modify equipment or add attachments that when servicing or performing maintenance on are not approved by Erskine Attachments LLC. hydraulic systems. • Use adequate safety warning lights and devices as •...

  • Page 5: Serial Number/Decal Location

    SERIAL NUMBER AND SAFETY DECAL LOCATIONS Serial Number Location: It is important to refer to the serial number of the attachment when making repairs or ordering parts. Early or later models (identification made by serial number) may use different parts, or it may be necessary to use different procedures in doing a specific operation.
  • Page 6 Location: On back of moldboard, both ends Quantity: 1 Quantity: 2 Safety Decals Locations: The locations of the safety decals are shown. If these decals are missing, damaged, or painted over they must be replaced. Call Erskine Attachments LLC (218-435-4045) for replacement decals.

  • Page 7: User's Mounting Instructions

    USER’S MOUNTING INSTRUCTIONS After the initial set-up assembly is completed, use the following procedure to mount the attachment to the loader. Coupler wedges or pins must extend through holes in attachment. Levers must be fully down and locked. Failure to secure wedges or pins can allow the attachment to come off and cause injury or death.
  • Page 8 USER’S MOUNTING INSTRUCTIONS 7. Connect the hydraulic quick couplers from the attachment to the loader. IMPORTANT: Wipe the ends of the hydraulic quick couplers (both lead and loader) with a rag remove possible contamination. Contamination can cause hydraulic components to fail and is not covered under warranty. IMPORTANT: Make sure the quick couplers are fully engaged.

  • Page 9: Operating Instructions

    4. Use the loader lift and tilt functions to increase traction and adjust the pitch of the v-plow. Blade Angle The v-plow utilizes a specially designed valve block to change the blade orientation without the requirement of an electrical attachment control system. The valve...

  • Page 10: Routine Maintenance

    ROUTINE MAINTENANCE Lower the attachment to rest flat on the ground, shut down the engine, relieve the hydraulic pressure to the attachment, set the park brake, and wait for all motion to stop before leaving the operator’s seat to perform service of any kind. It is the operator’s responsibility to make daily inspections of the loader and attachment for damage, loose bolts, fluid leaks, or anything else that could cause a potential service or safety problem.
  • Page 11 Grease all four cylinder bushings [C] every 8 hours of operation. Skid Shoe Height Adjustment 1. Raise the v-plow off of the ground and block up securely. 2. Remove the lynch pin [D] from the first skid shoe and slide the skid shoe out of the mount bushing.

  • Page 12: Parts Information

    STOCK NO. 311300 MOUNT V-PLOW W/A 422197 MOUNT V-PLOW MULTIHOG W/A MULTIHOG MOUNT 311379 MOLDBOARD V-PLOW 84 LH W/A USED ON 84” 311381 MOLDBOARD V-PLOW 96 LH W/A USED ON 96” 311383 MOLDBOARD V-PLOW 108 LH W/A USED ON 108”...
  • Page 13 PARTS INFORMATION...
  • Page 14 PARTS INFORMATION ITEM PART NO. DESCRIPTION STOCK NO. 311370 CYLINDER 2" X 10" B-B 311371 VALVE BLOCK 311373 HOSE 3/8 X 80 8FJX-6FJX LEAD 320089 ADPT ELB 8MB-6MJ-90 311374 HOSE 3/8 X 13 6FJX-6FJX90 CYL BASE TO A2 & B2 311375 HOSE 3/8 X 25 6FJX-6FJX90 CYL ROD TO A1 &...
  • Page 15 PARTS INFORMATION...

  • Page 16: General Specifications

    GENERAL SPECIFICATIONS Model 86” 98” 110” A) Straight Blade Width 69” 79” 89” B) Angled Blade Width 75” 85” 96” C) V Position Width 63” 73” 81” D) Scoop Position Width 31.8” E) Blade Height F) Blade Angle ± 36° G) Mount Flotation ±...

  • Page 17: Bolt Torque Information

    BOLT TORQUE INFORMATION...

  • Page 18: Notes

    NOTES ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________ ____________________________________________________...

  • Page 19: Warranty

    Erskine Attachments LLC to improve its products whenever it is possible and practical to do so. Erskine Attachments LLC reserves the right to make changes and or add improvements at any time without incurring any obligation to make such changes or add such improvements to products previously sold.
  • Page 20 P/N 311377 Date Printed: 11/13/2018 Printed in U.S.A. Erskine Attachments LLC...

Table of Contents