Igmp Status; Ping - EverFocus ES2446-51 User Manual

4.2.5 IGMP Status

IGMP Status
IGMP Status shows the IGMP Snooping statistics for the whole switch.
 VLAN ID: VLAN ID number.
 Querier: Show whether Querying is enabled.
 Queries transmitted: Show the number of transmitted Query packets.
 Queries received: Show the number of received Query packets.
 v1 Reports: Show the number of received v1 Report packets.
 v2 Reports: Show the number of received v2 Report packets.
 v3 Reports: Show the number of received v2 Report packets.
 v3 Leave: Show the number of v3 leave packets received.

4.2.6 Ping

This command sends ICMP echo request packets to another node on the network.
Ping Parameters
 Target IP Address: IP address of the host
 Count: Number of packets to send. (Range: 1-20)
 Time Out: setting the time period of host will be Ping
Use the ping command to see if another site on the network can be reached.
The following are some results of the ping command:
 Normal response: The normal response occurs in one to ten seconds,
depending on network traffic.
 Destination does not respond: If the host does not respond, a "timeout"
appears in ten seconds.
 Destination unreachable: The gateway for this destination indicates that the
destination is unreachable.
 Network or host unreachable: The gateway found no corresponding entry in the
route table.
Press <Esc> to stop pinging.
31
ES2446-51