Zanussi ZCAN10FW1 User Manual page 17

Climate
Ambient temperature
class
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be
guaranteed within the specified
temperature range.
LOCATION
The appliance should be installed well away from
any sources of heat, such as radiators, boilers,
direct sunlight, etc.
• Place the appliance in a horizontal position on a
solid surface.
• Make sure that the appliance stands level and
on all four feet. This can be achieved by two
adjustable feet at the bottom in front.
• To achieve the best performance, do not place
the appliance below overhanging wall units.
• Make sure the air can circulate freely around the
appliance.
Recommended clearance around the appliance:
min.
40 cm
The plug should be accessible after
the installation.
min.
80 cm
min.
40 cm
ELECTRICAL CONNECTION
• Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
• The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
• The manufacturer declines all responsibility if
the above safety precautions are not observed.
• This appliance complies with the E.E.C.
Directives.
HANDLE INSTALLATION GUIDE
Not applicable for models
ZCAN10FW1, ZCAN10EW1.
1. Take out the handle base and 2 screws from
the plastic bag.
2. Place the handle in position according to the
picture. Use Phillips screwdriver to fix the
handle base to the lid.
Open and close the lid several times to make sure
the handle is properly fastened.
17