Operation Instruction - iClever IC-OD41B User Manual

Operation Instructions
How to charge the Portable Power Station
There are two recharging port on the iClever IC-OD41B, including power via
a DC input port and the cigarette lighter port. The leftmost DC Input port is
able to be charged by a power adapter or solar panel that meets the voltage
requirements (17-25V). The left cigarette lighter interface is used to be
recharged by the car battery (Only support 12.5-16V battery).
When the charging mode begins, the corresponding charging mode icon will
flash on the LED display. "DC - >" and "car - >" represent adapter charging
and car charging respectively. At the same time, the battery indicator will
show the charging status.
This power station support recharging and discharging at the same time.
When the output power is greater than the input power (about 100w), the
battery percent will slowly decrease. When the battery percent drop to a low
power state, the output will be turned off.
Adopt BMS battery control tech, the charging progress of power station will
be finished automatically after being fully charged, thus avoiding battery get
damaged due to overcharge. However, it is suggested to unplug the device
after being fully charged.
Solar Energy Charging
Insert the plug of the solar panel into the "input" interface, the screen will
flash with "DC - >" , the battery indicator will show the charging status, and
the remaining time of being fully charged is displayed at the same time. The
power of the solar panel is greatly affected by the sunlight, resulting in the
dynamic change of the remaining time, which is normal.
- 08 -