Epson L351 Service Manual page 28

L350/L300/L355/L210/L110 Series
DISCHRGING INK FROM THE INK SUPPLY TANK
Discharging ink is recommended only when disconnecting the Ink Supply Tank Tube Assy from the Ink Supply
Tank. Before performing the above disconnection, discharge ink from the Ink Supply Tank as follows.
Necessary tools
Containers (x 6) for each discharged ink
•
Injector (with a tip of
•
Tube (capable to be connected to the joint)
•
Prior to the following steps, connect the injector with the tube, and then discharge ink
according to the procedure.
Discharging procedure
1. Remove the Housing Rear/Scanner Unit/Housing Left/Hinge/Housing Right.
2. With the choke value closed
than the top of the Printhead.
3. Prepare a container for ink to discharge, then disconnect the Ink Supply Tube from the joint and put its
tip into the container for the ink.
4. Open the choke valve to discharge the ink in the Ink Supply Tank Assy to the container.
Disassembly/Reassembly
φ 3.2 mm)
(p 27), place the Ink Supply Tank Assy on a place where its bottom is higher
Ink Supply Tank Assy
Ink Supply Tube
Joint
Figure 2-12. Discharging Ink (1)
Overview
Container for discharged ink
Revision B
28
Confidential