BenQ ScreenBar Halo User Manual page 16

Adjusting Brightness and Color Temperature
Brightness Control
Dark
Color Temperature Control
Warm
My Favorite Mode
Setting Up My Favorite Mode
Using My Favorite Mode
Tap the My Favorite Mode
Pairing and Connecting Multiple ScreenBar Halos
You can pair and connect a wireless controller with multiple lamps to operate at the same time.
If the distance between the controller and these lights is within 1 meter, the settings of these
lamps will change simultaneously.
Bright
Tap the Brightness Adjustment
control. The indicator will light up when the brightness control is on.
Rotate the adjustment ring to adjust the brightness and the lights around
the adjustment ring will change accordingly. Rotate the adjustment ring
clockwise to increase the brightness, or counterclockwise to decrease the
brightness.
Cold
Tap the Color Temperature Adjustment
temperature control. The indicator will light up when the color
temperature control is on. Rotate the adjustment ring to adjust the color
temperature and the lights around the adjustment ring will change
accordingly. Rotate the adjustment ring clockwise to increase the color
temperature (the highest color temperature is 6500K), or
counterclockwise to decrease the color temperature (the lowest color
temperature is 2700K).
If the power supply is interrupted, the brightness and color
temperature settings will be restored to the state before the power
interruption.
1. Adjust the brightness, color temperature and light mode of the lamp.
2. Tap and hold the My Favorite Mode
brightness, the color temperature and the auto dimming mode indicator
will flash three times simultaneously to indicate that the settings are
memorized successfully.
button to enter this mode.
1. Unplug the lamp.
2. Make sure that the power indicator is on (the wireless controller is
activated), and the wireless controller is within 1 meter of the lamp.
3. While holding the Light Mode Switch
Favorite Mode
indicators on the wireless controller start flashing simultaneously.
4. After the indicators start flashing, cover the
light sensor (on the reverse side of the light bar)
of the lamp you wish to pair then plug in the
USB power cord within 15 seconds. If the
controller and the lamps are successfully paired
and connected, all the indicators will turn off and the controller will go into
sleep mode.
button to activate brightness
button for about 3 seconds. The
button for about 5 seconds. You will see the function
button to activate color
button, tap and hold the My
English 3