Sears Craftsman C950-52816-0 Owner's Manual page 14

The snow blower operating controls and their functions
are as follows:
Speed Select Lever-- Allows the operator to use one of six
(6) forward and two (2) reverse speeds. To shift, move speed
select lever to desired position.
NOTE: Do not move speed select lever while Traction
Drive Clutch is engaged. This may result in severe
damage to drive system.
Auger Drive Clutch Lever-- Used to engage and disengage
the auger and impeller. To engage push down, to disengage
release.
Traction Drive Clutch Lever-- Used to propel snowthrower
forward or reverse. Push down to engage, release to
disengage.
Snow Chute Deflector- - Changes the direction the snow is
blown.
Crank (Not Shown) - Used to change direction of the
snow discharge. turn handle clockwise to turn chute to
right. Turn handle counterclockwise to turn chute to left.
OPERATION
Height Adjust Skid- - Used to adjust ground clearance of
auger housing (see To Adjust Skid Height in the
Adjustment/Repair section of this manual).
Toolbox - - Spare shear pins, shear bolt wrenches and
spacers are located in toolbox.
Clean-Out Tool - - Use the clean-out tool to remove snow and
debirs from the discharge chute and the auger housing.
Remote Deflector Control - Twist the knob to unlock
the chute deflector. Pull or push the knob to change the
deflector angle. UP provides a higher stream and greater
distance, while tilting the deflector DOWN provides a
a lower stream and less distance.
Drift Cutters (Not Shown) - Cuts a path through snow
higher than the auger housing.
14