American Standard Elevate 2947SWT36 Owner's Manual page 5

2
OSB BOARD INSTALLATION
FOR 36" CORNER
19-1/4"
(489 mm)
SUB-FLOOR
RIGHT WALL OSB
CUT/LOCATION DIMENSIONS
FOR 38" CORNER
1X3 FROM LEFT WALL FRAMING
9-3/4"
(248 mm)
SUB-FLOOR
RIGHT WALL OSB
CUT/LOCATION DIMENSIONS
2a. Cut and trim each piece of OSB board (Left and Right) according to the roughin above for the model in-
stalled. Mark and cut out clearance hole for rough plumbing. The OSB is used to provide additional
support for the walls and provide an area to apply adhesive for the wall panels.
2b. Place each piece of OSB board in position according to illustration, keeping it 2" above the shower base
and attach into place using screws (self-drill construction screws are recommended, but standard wood
screws can be used). TIP: Mark the location of the top and side of the OSB panels/door support on the
studs to make positioning them easier. NOTE: Ensure screw heads are flat to the OSB surface and do not
protrude.
2c. If installing a shower door, provide additional support using a 1x3" keeping it 1-1/4" (31.8 mm) off the deck
of the shower base and screw into corner framing. Chamfer outer edges if necessary. (ref. illustration)
OSB Wall Panels Only
Model Right Walls
2947SWT38 20-7/8" x 68-7/8" (530 x 1749 mm)
2947SWT38 23-7/8" x 70-7/8" (606 x 1800 mm)
32-1/8" (816 mm)
1X3 FROM LEFT WALL FRAMING
11-3/8"
(289 mm)
68-7/8"
(1749 mm)
2" (50.8mm)
FROM
FIXTURE
DECK
1-1/4"(31.8mm)
1x3 SPACING FROM
FIXTURE DECK
35-1/8" (892 mm)
23-7/8"
(606 mm)
70-7/8"
(1800 mm)
2" (50.8mm)
FROM
FIXTURE
DECK
1x3 SPACING FROM
FIXTURE DECK
32-1/8" (816 mm)
1X3 FROM RIGHT WALL FRAMING
19-1/4"
(489 mm)
68-7/8"
(1749 mm)
2" (50.8mm)
FROM
FIXTURE
DECK
LEFT WALL OSB
CUT/LOCATION DIMENSIONS
35-1/8" (892 mm)
1X3 FROM RIGHT WALL FRAMING
22-1/4"
(565 mm)
70-7/8"
(1800 mm)
2" (50.8mm)
FROM
FIXTURE
DECK
1-1/4"(31.8mm)
LEFT WALL OSB
CUT/LOCATION DIMENSIONS
Left Wall
19-1/4" x 68-7/8" (489 x 1749 mm)
22-1/4" x 70-7/8" (565 x 1800 mm)
11-3/8"
(289 mm)
SUB-FLOOR
11-3/8"
(289 mm)
SUB-FLOOR
1x3 Door Support,
PINE, not OSB
70-1/2" (1791 mm)
72-1/2" (1842 mm)