Sending The Dtmf Code By Autodialer - Yaesu FT-25R Advance Manual

DTMF Operation
6. Press the [1] - [0] key, the [P1] - [P4] key, [ MR], [#VFO],or use the[▲] and [▼] keys
to select the first digit of the DTMF string.
7. Press the F key to accept the first digit and move to the next digit of the DTMF string.
8. Repeat step 6 - 7 to complete the telephone number.
To correct a mistake, press the F key repeatedly (or press and hold the F key and then
press the F key) until the cursor returns to the first character position and then begin
the DTMF Memory entry again.
9. Press and hold the F key to save the telephone number.
10. Press the PTT switch to return to normal operation.
To monitor and check the entered DTMF strings, repeat steps 1- 4
above, then press the [▲] or [▼] key to select the input register, and
then press the MONI/T.CALL key.

Sending the DTMF code by Autodialer

1. Press and hold the F key to enter the Set mode.
2. Press the [▲] or [▼] key to select Set Mode Item "12 DTMF SET".
3. Press the F key to enable adjustment of this Set Mode Item.
4. Press the F key, then press the [▲] or [▼] key to
select "AUTO".
5. Press the F key to save the new setting.
6. While pressing the PTT switch to transmit, press a registered DTMF Memory key
[1] - [9].
7. Release the PTT switch.
The DTMF tone signals will continue to be transmitted until the number is completed.
To change the DTMF Autodialer sending delay and speed, use the Set
Mode Item "12 DTMF SET". See page 37 for details.
FT-25R/FT-25E Advance Manual
29