Advertisement
Available languages
Available languages
2 . Be aware that this tool is always in operating condition,
because it does not have to be plugged into an electrical outlet .
3 . Always be sure you have firm footing .
4 . Be sure no one is below when using the tool in high locations .
5 . Hold the tool firmly and use both hands .
6 . Keep hands and hair away from rotating parts .
7 . Do not leave the tool running . Do not force tool to stay in the
"on" position . Operate the tool only when hand-held .
8 . Do not touch the drill bit, impact socket, any adapter, or the
workpiece immediately after operation; they may be extremely
hot and could burn your skin .
OPERATING INSTRUCTION
Installing Or Removing Battery Pack
1 . Your new battery pack is not fully charged . You may need to
charge before use .
2 . Make sure the forward/reverse lever is in the neutral position
when installing or removing a battery .
3 . To remove a battery, depress the front tab and pull the
battery forward and the tool in the opposite direction .
4 . To install a battery align the tool with the battery, place the
front of the tool about halfway up the battery, push forward
until click is heard indicating full installment .
Charging The Battery Pack
1 . Battery may not charge when it is above a certain preset
temperature limit . Allow temperature of battery to cool before
charging .
2 . The charge process will take less than one hour .
3 . After charging, unplug the charger from the power source
and stow away in a safe place .
MCL144DD
MCL144DD 14.4V 3/8" Drill Driver
3
9 . Some material contains chemicals which may be toxic . Take
caution to prevent working dust inhalation and skin contact .
Follow material supplier safety data .
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Tool Operation
1 . Turn the hand chuck collar counterclockwise to loosen while
holding the chuck handle still . Insert the bit and center into
the chuck . Turn the chuck collar clockwise to tighten and
make sure that the bit is firmly held within the chuck .
2 . Run the tool to ensure tightness before placing the tool and
bit onto work .
3 . Forward and reverse switch is actuated by a sliding
mechanism located above the handle .
4 . Select the appropriate torque setting on the dial clutch .
rev. 09/09/09
Advertisement
