Installing And Charging The Battery; To Install The Battery - General Dynamics Itronix GoBook MR-1 Getting Started Manual

Installing and Charging the Battery

The Lithium-Polymer battery supplied with your computer should be fully
charged before you operate the unit on battery power. To optimize battery
capacity, follow the recommendations for battery calibration in the GoBook
MR-1 User Help (provided on your computer).

To install the battery

1. Close the display and turn the computer over, display side down, so that
the computer is resting on the closed display.
2. Install the battery pack into your GoBook
• Place the clips on the battery into the slot on the bottom of the
GoBook
®
• Slide the battery in the opposite directon of the arrows until it clicks
into place.
NOTE To remove the battery, press the release buttons and push the
battery in the direction of the arrows. The battery can be removed
completely from the main unit.
3. The battery starts charging automatically when external power is
connected. The computer's external Power LED on the indicator panel
remains ON while connected to external power. The Battery LED on the
indicator panel is ON while the battery is charging. When the battery is fully
charged, or not accepting a charge, the Battery LED is OFF.
At moderate temperatures, approximately 70° F (21° C), the battery will be
fully charged in about 4 hours. In extremely hot or cold temperatures, it may
take up to 16 hours to charge the battery.
73-0174-001 2007.07.23
INTRODUCTION
MR-1 as shown.
MR-1 as shown below.
®
®
9