Tools Needed To Remove Or Install Blade; Tools Needed For Adjustment; Assembly And Adjustments - Black & Decker M1850BD TYPE 2 Instruction Manual

TOOLS NEEDED TO REMOVE
OR INSTALL BLADE
B
lade Wrench with
Phillips Head End and
6 mm Hex Head End
TOOLS NEEDED FOR
ADJUSTMENT
Not Supplied
Adjustable Wrench
Combination Square
Supplied
ASSEMBLY AND
ADJUSTMENTS
WARNING
!
• To avoid injury, do not connect this
miter saw to the power source until
it is completely assembled and
adjusted, and you have read and
understood this Instruction Manual.
• To reduce the risk of injury, turn
unit off and disconnect it from
power source before installing
and removing accessories, before
adjusting or when making repairs.
An accidental start-up can cause
injury.
TRANSPORTING THE SAW (FIGURE A)
WARNING
!
• To reduce the risk of injury, turn unit
off and disconnect it from power
source before installing and removing
accessories, before adjusting or
when making repairs. An accidental
start-up can cause injury.
• To reduce the risk of serious
personal injury, ALWAYS lock the
miter table locking lever, bevel lock
handle, and hold-down latch before
transporting saw.
• In order to conveniently carry the miter
saw from place to place, use the hand
holds (1) on the base.
A
1
RELEASING THE CUTTING HEAD
(FIGURE B)
WARNING
!
damage to the saw, transport or store
the miter saw with the cutting head
locked in the down position. Never
use the hold-down latch to hold the
cutting head in a down position for
cutting operations.
12
To avoid injury and