Advertisement
2.4 Communications Connections
The ports as you look at the back of the case, are the ports for connecting to a PLC or some external
device (Controller Connectors).
2.4.1 Connector COM1 [RS232], COM2 [RS232]
Different cables are required for various devices. Restrict cable length to less than 500'
Cable
(150m) for RS485/422 devices and 50' (15m) for RS232 devices to avoid
Requirements
communications problems.
Caution
The COM light on the front of the MT-600/8000 will turn on with each Ethernet
communication. Shielded cable must be used for long lengths or cables run in an
electrically noisy environment.
Do not run cables next to AC power lines or near sources of electrical noise. Be sure
that the cable ends have been inserted all of the way into mating connectors and are
secure
Pin assignment of the 9 Pin, Male, SUB-D, COM1 [RS-232] and COM2 [RS-232] Port.
Pin Designations
COM1 [RS-232]
COM2 [RS-232]
2.4.2 Connector COM1[RS485] , COM3[RS485] and COM3[RS232]
The 9 Pin, Female, SUB-D, COM1 [RS-485], COM3 [RS-485] and COM3 [RS-232] Port on the back
of the unit is the RS-232 and RS485/422 communications port for connecting to a controller.
Connection
Pin Designations
COM1 [RS-485]
COM3 [RS-485]
COM3 [RS-232]
* The Com1 RS232/RS485 2wire/4wire, Com3 RS232/RS485 mode can be set by CECP.(In the Windows CE
desktop)
Pin#
Symbol
COM1 [RS232]
1
Not used
2
RxD
Received Data
3
TxD
Transmitted Data
4
TxD
5
GND
6
RxD
7
RTS
Ready to send output
8
CTS
Clear to send input
9
Not used
Pin assignment of the 9 Pin, Female, SUB-D COM1 [RS-485], COM3
[RS-485] and COM3 [RS-232] Port
Pin# Symbol Com1
1
Rx-
2
Rx+
3
Tx-
4
Tx+
5
GND
6
Data-
7
TxD
8
RxD
9
Data+
Signal Ground
Com1
[RS485]2w
[RS485]4w
Data-
Rx-
Data+
Rx+
Tx-
Tx+
Signal Ground
5
COM2 [RS232]
Transmitted Data
Received Data
Com3
Com3
[RS485]
[RS232]
Data-
Transmit
Receive
Data+
Advertisement
