Electrolux EI23BC51 Use And Care Manual page 7

Leveling Freezer Drawer (if nec-
essary)
NOTE
DO NOT remove center screw from freezer drawer.
This is a factory adjustment.
To level the cabinet using the front rollers (select
models):
1 Slightly open freezer drawer. Lift the toe grille
and gently pull forward (see illustration).
2 Check gasket seal around top, bottom, and sides
of freezer drawer.
3 If gasket is not sealed, open drawer and slightly
loosen four (4) drawer screws (two (2) on each
side) to allow drawer to rotate.
4 Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
Drawer
Screw
Drawer
Screw
5 Tighten four (4) drawer screws.
6 Recheck gasket seal.
Push Against
Freezer Drawer
A
7 Install the toe grille by fitting into place.
Drawer
Screw
Drawer
Screw
Grab Drawer
At Center
From Both Sides
Then
Pull Drawer Out
B
Level Refrigerator & Adjust
Doors (if necessary)
Guidelines for final positioning of your refrigerator:
• All four corners of the cabinet must rest firmly on
the floor.
• The sides should tilt
to back (to ensure that doors close and seal
properly).
• Doors should align with each other and be level.
Most of these conditions can be met by raising or
lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1 You can raise or lower each door. use a 3/8 inch
socket wrench to turn the adjustment screws (1
per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw
counterclockwise.
2 Ensure both doors are bind-free with their seals
touching the cabinet on all four sides and that
cabinet is stable.
3 After unit is leveled, lower anti-tip leg until it
contacts the floor.
Door
Anti-tip
Leg
Installation
/ inch (6 mm) from front
1
4
Door
Raise
Lower
7