ABB TPL76-C33 Operation Manual page 109

Operation Manual / TPL76-C
8 Disassembly and assembly / 8.7 Installing cartridge group
Clearance A [mm]
© Copyright 2018 . All rights reserved.
Measuring and checking axial clearance
WARNING
Risk of injury due to sharp edges on the compressor wheel
The compressor wheel has sharp edges which can cause injuries.
Wear safety gloves.
u
Wear safety gloves to protect against mechanical hazards.
Measure and note axial clearance A.
u
CAUTION
If the axial clearance (A) is out of tolerance, an official ABB Turbo Sys-
tems service station must be contacted.
Connect oil lines and all air lines in accordance with engine builder
u
specifications.
Fit filter silencer or air suction branch and fasten with nuts (74027)
u
and washers (74018).
Refit insulation if it was removed.
u
HZTL2485_EN
TPL76-C
0.43 ... 0.69
Revision F April 2018