Before You Start INSTALLATION Safety instructions are on pages 3 and 4, and installation instructions are on pages 11 to 15. Please complete these steps: 1. Read the safety instructions. 2. Read all instructions in the Installation section of this manual BEFORE installing the range hood. 3.
Page 3
Important Information Read All Safety Instructions Please follow all instructions before using the product to prevent the risk of fire, electric shock, personal injury or damage when using it or using devices in combination with the product. This guide does not cover all possible conditions that may occur.
Page 4
Important Information WARNING: TO REDUCE THE RISK OF A COOKING OVEN GREASE FIRE: •Clean the ventilation fans as much as possible. Do not allow cooking residue to accumulate on the fan or filter. Before servicing the device, be sure to turn off the power source. Your safety and the safety of others are important.
Parts Included Range Hood 2 Filters (28 po) Damper Flap 2 Filters (34 po) Note on hardware: For safety reasons, screws and fixings for fixtures are not included due to variations in cabinet constructions and wall materials. Please consult your installation specialist regarding the optimal type of mounting screws and wall fixings required depending on the construction of your home.
Hood Dimensions Specifications Acier inoxydable Body Power Rating 120V/60Hz or 220V/50Hz (USA / CAN standard) 220W (190W + 2 X 2,5W) General Input Power 190W Motor Input Power 600 CFM Maximum Airflow 800 RPM (+/- 10 %) to 1600 RPM (+/- 10%) Motor Revolution Air Pressure 3,4 A...
Control Panel Turn On: • Press the speed control (Low Speed, Medium Speed, High Speed) switch to select the desired level of power. Once button is pressed, the previous speed mode will cancel. • Press the Light Switch to power on the lights. Turn Off: •...
Electrical Requirements IMPORTANT: Observe all governing codes and ordinances. (THIS HOOD REQUIRES 120V POWER TO OPERATE PROPERLY) It is the customer’s responsibility: To contact a qualified electrical installer. To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/ NFPA 70 —...
Troubleshooting Guide CAUTION: Touching the exposed electrical connectors or other electronic circuits inside this hood when the power is on could result in death, serious injury, or property damage. 1. If the range hood does not operate after installation: Check if the range hood has been plugged in, make sure that all power has been turned back on and all electrical wiring are properly connected.
Installation STEP 1 Read Safety Instructions • Read the safety instructions on pages 4 and 5 before installing. IMPORTANT: It is the responsibility of the installer to comply with the manufacturer's safety and installation standards. STEP 2 Unpack the Kitchen Hood and Prepare the Tools •...
Page 12
Installation STEP 5 Ventilation Installation Guidelines • The following steps are described for the installation of outdoor ventilation.
Page 13
Installation IMPORTANT: • • It is important to install the hood at the A minimum 6 '' (15.2 cm) circular or 3 1/4 x 10 correct mounting height. Hoods set too low '' (25.4 cm x 8.3 cm) rectangular duct could cause heat damage and pose a fire (purchased separately) should be used to hazard;...
Page 14
INSTALLATION IMPORTANT: NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. All exhaust must be ducted to the outside. • Use metal/aluminum duct work only. • Fasten all connections with sheet metal screws and tape all joints with certified Silver Tape or Duct Tape.
Page 15
Installation STEP 6 Preparations NOTE: To avoid damage to your hood, prevent debris from entering the ventilation opening. • Determine and mark the center line on the ceiling and on the range hood before installation. Make sure there is adequate clearance in the ceiling or wall for the ventilation duct. •...
Warranty Services Please provide original dated proof of purchase (receipt / invoice) in order to obtain warranty service. One year parts warranty: For one year from the date of original purchase, your local dealer will provide free replacement parts or non-consumable components that are defective due to manufacturing defects. Subject to the conditions and limitations set out below, your local dealer will, at its discretion, repair or replace any part of its products that turns out to be defective due to improper manufacturing or materials.
Page 17
If you need help or need additional product information, please visit our website: www.myturin.com...
Need help?
Do you have a question about the ELITE E70-30 and is the answer not in the manual?
Questions and answers