ΠDraining The Condensation; Water - Siemens WT47RT90GB Installation And Operating Instructions Manual

Table of Contents

Advertisement

Saving and exiting the appliance
settings
Save and exit the appliance settings as
follows:
1.
Turn the programme selector to
switch off the appliance.
2.
Wait 5 seconds.
Note:
The selected settings are
retained even after the appliance has
been switched off.
Draining the condensation water
Œ
Draining the
condensation water
C ondensation will form in the appliance
D r a i n i n g t h e c o n d e n s a t i o n w a t e r
as it dries the laundry.
You must ensure that the drain hose is
connected when you operate the
appliance.
If there is no drain hose connected to
the appliance, the condensation water
from the appliance will run into the
condensation container. In this case,
you will need to empty the condensation
container each time the dryer finishes
drying the laundry, and also if it
becomes full before drying is complete.
Connect the drain hose as follows:
1.
Remove any accessories from the
drum.
2.
Remove all items from the bag.
en
35

Advertisement

Table of Contents
loading

Table of Contents