EMC VNX VNX5200 Installation Manual page 25

Installing the components Installing the components
Some components are heavy and may require two people. If needed, use an appropriate lifting Some components are heavy and may require two people. If needed, use an
device (mechanical lift). device (mechanical lift).
Installing the disk processor enclosure Installing the disk processor enclosure
You Your disk proce
Disk-processor enclosure Disk-processor enclosure
SP SP
A A
01 01
Disk-processor enclosure Disk-processor enclosure
Fi Figur gure e 5 5 Front and Rear view of DPE
Note: Note:
module and five slots for I/O module and five slots for I/O modules, numbered 0-4. Slots 0 and 1 in
indicating that those slots are indicating that those slots are not supported.
 
r disk processor enclosur ssor enclosure is a 3U, 25
Front Front
Caution:ArraySoftwareondrives0-3.Removingorrelocatingthem Caution:ArraySoftwareondrives0-3.Removingorrelocatingthem
Will Make the Array Unusable Will Make the Array Unusable
1 1 0 0
X4 X4 X4 X4
C C
C C
Front and Rear view of DPE
The DPE contains two Storage Processors (SP A and SP B). Each SP contains a management The DPE contains two Storage Processors (SP A and SP B). Each SP contains a management
e is a 3U, 25 2.5" drive D 2.5" drive DPE as shown in
front front
Disk-processor enclosure Disk-processor enclosure
rear rear
! !
D D
A A
modules, numbered 0-4. Slots 0 and 1 in each SP have covers
not supported.
appropriate lifting
PE as shown in Fi Figu gure re 5 5 . .
(Jetfire) (Jetfire)
1 1 0 0
X4 X4 X4 X4
! !
C C D D
C C A A
each SP have covers
Installing the components Installing the components
4 4
SP SP
B B
01 01
15 15