A
D
UTO
RIVE WITH
Hand control disable, disables all functions on the hand control.
1. To disable, press and hold the program button (SP) for 4 seconds until the
backlight starts flashing. Then press button (S7).
2. To enable, press and hold the program button (SP) for 4 seconds until the
backlight starts flashing. Then press button (S7).
Should you ever want to limit the button function of your hand control, you can
use the function lock feature to disable all button function except for buttons (S7
and S9).
1. To lock function, press and hold the program button (SP) for 4 seconds until
the backlight starts flashing.
2. Press button (S1), press button (S2), press button (S3), press button (S6).
3. To unlock function, press and hold the program button (SP) for 4 seconds until
the backlight starts flashing.
4. Press button (S1), press button (S2), press button (S3), press button (S6).
From time to time your electrical system may need to be calibrated. This can be
attributed to motor drift over time or an electrical component replacement.
To calibrate the hand control:
Press and hold buttons S1, S3, and S11 until the chair stops moving. The chair
will be in a reclined position with the foot rest extended.
Calibration is now complete.
This feature will automatically shut off the backlight on the hand control after a
specified period of inactivity (approximately 15 seconds).
To activate the "Lights Out Feature", follow the procedure below.
1. Press and hold "M", until the backlight starts flashing.
2. Press the key sequence: Backrest down, Backrest up, and SIT.
To turn off the "Lights Out Feature", repeat steps 1 – 2.
T
-C
WILIGHT
Hand Control Disable
Function Lock
Hand Control Calibration
Lights Out Feature:
O
ONTROL
PERATION
12
-
CONTINUED