Contents Important Safety Your wireless speaker Introduction What's in the box Overview of the speaker Get started Charge the built-in battery Play from Bluetooth devices Play from Bluetooth devices Control playback Product information Troubleshooting General Bluetooth Notice Compliance Care of the environment FCC Statement Trademark notice...
1 Important • Disposing a battery into fire or a hot oven, mechanically crushing or cutting a battery can result in an explosion. • Leaving a battery in an extremely high temperature surrounding, or an extremely low air pressure environment may result in Safety an explosion or leakage of flammable liquid or gas.
• Turn the speaker on or o . Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product DC IN at www.philips.com/welcome. • Charge the built-in battery.
3 Get started Power on When the speaker is being charged, LED is solid Red. When the speaker is fully charged, Always follow the instructions in this chapter in LED is solid Blue. sequence. Power o Charge the built-in battery Charge the built-in battery When the speaker is being charged, LED is solid Red.
After successful pairing and connection, » you'll hear the prompt sound, and the LED indicator turns solid blue. If you cannot find [Philips S1505] on With this speaker, you can listen to audio from your device, hold down the Power Bluetooth-enabled devices.
3.7 V,480 mAh 64 x 64 x 78mm 0.14 Operation Ambient 0 ~40 IP protection class IPX7* *The IPX7 rating means the speaker driver can be submerged for up to 30 minutes at a depth 2.5W RMS of up to 1 m. 150Hz-18kHz 1.5"...
Philips S1505 If you cannot find [Philips S1505] on your device, hold the for 2 seconds to power off, and then long press the button for 6 seconds to clear the pairing information / enter pairing mode.
Directive 1999/5/EC. You can find the Declaration of Conformity on www.philips.com/support. Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
FCC Statement Trademark notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must ® The Bluetooth word mark and logos are accept any interference received, including registered trademarks owned by the Bluetooth interference that may cause undesired...
Page 11
Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its a liates, and MMD Hong Kong Holding Limited is the warrantor in relation to this product.