Contents Important Safety Your wireless speaker Introduction What's in the box Overview of the speaker Get started Charge the built-in battery Play from Bluetooth devices Play from Bluetooth devices Control playback Control phone call Product information Troubleshooting General Bluetooth Notice Compliance Care of the environment FCC Statement...
1 Important • Disposing a battery into fire or a hot oven, mechanically crushing or cutting a battery can result in an explosion. • Leaving a battery in an extremely high temperature surrounding, or an extremely low air pressure environment may result in Safety an explosion or leakage of flammable liquid or gas.
Show the Bluetooth status. Clear Bluetooth pairing information. Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product Press to turn the Multi-color LED light on at www.philips.com/welcome. or off.
3 Get started Power on When the speaker is being charged, LED is solid Red. When the speaker is fully charged, Always follow the instructions in this chapter in LED is solid Blue. sequence. Power o When the speaker is being charged, Charge the built-in battery LED is solid Red.
After successful pairing and connection, » you will hear the prompt sound and Bluetooth the LED indicator turns solid blue. If you cannot find [Philips S2505] on devices your device, press and hold for more than three seconds until you the prompt sound.
91.5 x 91 x 41mm 0.19 Operation Ambient 0℃~40℃ IP protection class IPX7* *The IPX7 rating means the speaker driver can be submerged for up to 30 minutes at a depth 6W max of up to 1 m. 120Hz - 18kHz 1.75"...
Philips S2505 If you cannot find [Philips S2505] on your device, hold down the button for 2 seconds to power off before rebooting, or short press it to enter pairing mode.
Directive 1999/5/EC. You can find the Declaration of Conformity on www.philips.com/support. Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that...
FCC Statement Trademark notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must ® The Bluetooth word mark and logos are accept any interference received, including registered trademarks owned by the Bluetooth interference that may cause undesired...