Spi Interface - Mcube MC3479 Quick Start Manual And Demo

MC3479 3-Axis Accelerometer

2.2 SPI INTERFACE

The EV3479A evaluation board can be easily wired to any microcontroller. This example
shows a typical Arduino DUE platform. Please refer to the illustration below for connecting the
related pins and then port the code to get the raw X, Y, Z sensor data.
•
Connect DVDD to the power supply, 3.3V.
a voltage exceeds the maximum rating of 3.6V is likely to damage it.)
•
Connect GND to common power/data ground.
•
Connect SCL to ICSP-3 as Serial Clock.
•
Connect SDO to ICSP-1 as Master Input, Slave Output.
•
Connect SDA to ICSP-4 as Master Output, Slave Input.
•
Connect SCS to digital I/O pin 10 as
mCube Proprietary.
© 2020 mCube Inc. All rights reserved.
EV3479A Quick Start Guide and Demo
(WARNING: attempting to power the part at
Slave Chip Select.
APS-045-0034v1.0 7 / 20