Table of Contents
Advertisement
MC3672 3-Axis Accelerometer
2.2 SPI INTERFACE
The EV3672A/B evaluation board can be easily wired to any microcontroller. This example
shows a typical Arduino DUE platform. Please refer to the illustration below for connecting the
related pins and then port the code to get the raw X, Y, Z sensor data.
•
Connect DVDD to the power supply, 3.3V. (WARNING: attempting to power the part at
a voltage exceeds the maximum rating of 3.6V is likely to damage it.)
•
Connect GND to common power/data ground.
•
Connect SCL to ICSP-3 as Serial Clock.
•
Connect SDO to ICSP-1 as Master Input, Slave Output.
•
Connect SDA to ICSP-4 as Master Output, Slave Input.
•
Connect SCS to digital I/O pin 10 as Slave Chip Select.
mCube Proprietary.
© 2020 mCube Inc. All rights reserved.
EV3672A/B Quick Start Guide and Demo
APS-045-0017v1.5
8 / 21
Advertisement
Table of Contents
