Jensen DUAL CMR2629 Installation & Owner's Manual page 4

CMR2629 OPERATION
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it
would be subject to dust, dirt or excessive vibration.
Getting Started
• Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness as shown on page 6. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
• Reconnect negative battery terminal, and test for correct operation.
• Snap trim ring into place (if required).
• Slide unit into mounting sleeve to secure.
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
3
Preparation
Main Unit
Trim Ring
Taptite Truss
Head 5x6mm
Taptite Binding
Head 5x6mm