Cabinet Construction; Countertop Preparation - Electrolux EW30ES65G Installation Instructions Manual

30" electric slide-in range
Hide thumbs Also See for EW30ES65G:
Table of Contents

Advertisement

Available languages

Available languages

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
Where local codes DO NOT permit connecting the
appliance-grounding conductor to the neutral
(white) wire, or if connecting to 4-wire electrical
system (see Figure 7):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the circuit breaker, fuse box or junction box:
a) Connect the white appliance cable wire to the
neutral (white) wire.
b) Connect the 2 black wires together.
c) Connect the 2 red wires together.
d) Connect the green (or bare copper) grounding
wire to the grounding wire of the circuit breaker,
fuse box or junction box.
Cable from Residence
Green (or Bare
Copper) Wire
Red
Wires
Green (or Bare
Copper) Wire
Junction
Box
Cable from
Appliance
Figure 7 – 4-Wire Electrical System
(Example: Junction Box)
4.
4.1
4.2
White Wire
Black
Wires
White Wire
U.L.-listed Conduit
Connector (or CSA
listed)
4.3
(5.56 cm)
2 3/16"
(5.56 cm)
29"
(73.7 cm)
4 3/8" Min.
(11.4 cm)
30"
(76.2 cm)
1¼"
(3.2 cm)
8

Cabinet Construction

To eliminate the risk of burns or fire by
reaching over heated surface units, do not have cabinet
storage space above the range. If there is cabinet
storage space above range, reduce risk by installing a
range hood that projects horizontally a minimum of 5"
(12.7 cm) beyond the bottom of the cabinet.

Countertop Preparation

• The cooktop sides of the range fit over the cutout edge
of your countertop.
• If you have a square finish (flat) countertop, no
countertop preparation is required. Cooktop sides lay
directly on edge of countertop.
• Formed front-edged countertops must have molded
edge shaved flat 3/4" (1.9 cm) from each front corner
of opening (Figure 8).
• Tile countertops may need trim cut back 3/4"(1.9
cm) from each front corner and/or rounded edge
flattened (Figure 8).
Min.
Cutout
Width
¾"
(1.9 cm)
• If the existing cutout width is greater than
30 1/16" (76,4 cm), reduce the ¾" (1.9 cm)
dimension.
• Countertop must be level. Place a level on the
countertop, first side to side, then front to back. If the
countertop is not level, the range will not be level. The
oven must be level for satisfactory baking results.
Cooktop sides of range fit over edges of countertop
opening
For existing cutout width of 29"
IMPORTANT
(73.7 cm) (Figure 9):
2 3/16"
You must also clear 2 3/16"
(5.56 cm) of material from
front of countertop.
1¼"
(3.2 cm)
31½"
(80 cm)
Formed or tile countertop trimmed 1¼"
(3.2 cm) back at front corners of
Figure 9
countertop opening.
¾"
(1.9 cm)
31½"
(81 cm)
Formed or tile countertop
trimmed ¾" (1.9 cm) back at
front corners of countertop
opening.
Figure 8

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ew30es65gsEw30es6cgwEw30es6cgsEw30es6cgb

Table of Contents