Auto Restart Setting; Maintenance; Operation And Performance - Toshiba 13J2KCVRG-T Owner's Manual

AUTO RESTART SETTING

This product is designed so that after a power failure, it can restart automatically in the same operating mode as
before the power failure.
The product was shipped with Auto Restart function in the OFF position. Turn it ON as required.
Press and hold the Temporary switch on the indoor unit for 3 seconds to set the operation
1
(3 "Pi" sounds and OPERATION lamp blinks 5 times/sec for 5 seconds).
Press and hold the Temporary switch on the indoor unit for 3 seconds to cancel the
2
operation
(3 "Pi" sounds but OPERATION lamp does not blink).
In case the ON timer or OFF timer is set, Auto Restart operation does not activate.

MAINTENANCE

Firstly, turn off the circuit breaker.
Indoor Unit and Remote Control
Clean the indoor unit and the remote control with a wet cloth when needed.
No benzine, thinner, polishing powder or chemically-treated duster.
Air filters
Clean every 2 weeks.
1. Open the air inlet grille.
2. Remove the air filters.
3. Vacuum or wash and then dry them.
4. Reinstall the air filters and close the air inlet grille.

OPERATION AND PERFORMANCE

1. Three-minute protection feature: To prevent the unit from being activated for 3 minutes when suddenly restarted or switched to ON.
2. Some minor cracking sound may occur when unit operating. This is normal because the cracking sound may be caused by expansion/contraction of plastic.
Air conditioner operating conditions
Temp.
Operation
Cooling
Dry
29
1122350201_00_S03_182x257_64p_S_p70_190208.indd 28
How to set the Auto Restart
How to set the Auto Restart
Outdoor Temperature Room Temperature
--10 °C ~ 46 °C
--10 °C ~ 46 °C
21°C ~ 32°C
17°C ~ 32°C
2/23/2019 11:05:37 AM