Table of Contents
Advertisement
DISASSEMBLY
INSTRUCTIONS
1. Press the switch to the STOP position and then
unplug the Slow Juicer.
2. Make sure the smart cap that stops juice flow is
in the closed position is in the closed position.
Remove the juice jug.
3. Unlock the cover by twisting it counterclockwise
and then remove from the juicing bowl. Remove
the food pusher from the cover.
4. Remove auger, strainer assembly and then
juicing bowl.
OPERATING
INSTRUCTIONS
1. Make sure your Slow Juicer is properly
assembled. (See Assembly Instructions, page 6.)
2. Plug the power cord into a 230 - 240V electrical
outlet.
3. NEVER PROCESS hard nuts, pits and seeds as
these can damage the juicer and void the
warranty. Hard nuts, pits and seeds can
damage the juicer.
4. Wash all selected fruits and vegetables.
5. Place fruits and vegetables into the feed chute
with use of the pusher. Larger items can be added
to the feed chute by lifting the hopper cap and
placing directly on the plate hopper to juice.
6. While many fruits and vegetables will not need
cutting, any item with a diameter larger than
7cm will need to be cut.
7. Press the switch to the ON position when ready
to commence juicing.
REVERSE - Press the REV switch to reverse the
direction of the juicer to help clear the auger
and any clogging in the juicing area. to clear the
auger to avoid clogging of the juicing area.
8. Ensure the pulp and juice containers are in place
before juicing then open the pulp spout and the
juicing spout for the juice to flow into the juice
jug and the pulp to accumulate in the pulp
container.
NOTE: Pay close attention when operating with
the juice cap closed. Juice may overflow if the
juice collected in the juicing bowl exceeds its
capacity.
9. When finished juicing, press the switch to the
STOP position to stop the motor.
10. If the machine suddenly shuts down while
operating, press the STOP switch first and then
press the REVERSE button. To make the food in
the auger come up, release and then press the
ON switch. Repeat 3 times.
a) When the machine is in reverse, gently press
the lid to prevent the lid from becoming loose.
b) If the machine is still not working, disassemble
it and then wash before trying again.
CLEANING AND
MAINTENANCE
Do not immerse the motor base in water or spray it
with water. Clean only by wiping with a damp
sponge, cloth or paper towel. Use any liquid
dishwashing detergent, but do not use any products
containing ammonia or scouring powders, as these
products will dull, scratch or mar the finish.
For easy cleanup, remove excess pulp from the
juice strainer and the lid after each use. RINSE
CLEAN and AIR DRY for next use. Vegetables and
fruits will harden if left to dry on the unit parts,
making it harder to clean.
•
Unplug juicer and carefully take it apart,
following Disassembly Instructions on this page.
•
Rinse all removable parts with cold water.
•
Wash the pulp container, juice container, cover,
pusher, feed tube with hopper and juice strainer
assembly in hot, sudsy water, or on the top rack
of dishwasher. Do not use a metal brush or pad.
•
Towel-dry all parts.
•
Any other servicing should be performed by an
authorized service representative.
7
Advertisement
Table of Contents
