Table of Contents
Advertisement
PRESSURE SETTINGS
G. Adjust the pressure screwing or unscrewing the screw (knurled knob - 4), pull down the
heat plate with its handle (3), screw or unscrew the other knurled knob (5) so that it touches
the surface of the support (6).
H. When the press reaches the necessary temperature*, place the support to be printed and
the logo on the lower plate and close down the heat plate using the handle. (3).
I. The screen (B) shows the count down, the buzzer rings to notify that the transfer time is
over. Raise the heat plate.
K. The transfer is done.
* See the correspondent guidelines as to transfer conditions (time, temperature, pressure,
weeding...).
7
S.A.R.L. au capital de 15 250 €
SIRET : 408 484 913 00012
APE : 514 S
R.C.S. CRETEIL
N° de TVA intra-communautaire : FR 13 408 484 913
Advertisement
Table of Contents
