Electrical Information; Grounding Instructions - Edic GALAXY Owner's/Operator's Manual

• All repairs must be done by an authorized
EDIC repair station.
• Do not use replacement parts other than original
EDIC parts.
• Do not allow your spray stream to remain in one
fixed location as surface damage may occur.
• Check that all spray nozzles are securely fastened.
Loose nozzles could be ejected from equipment at
high speeds.
• This is not a toy. Keep away from children.
• Do not pull by the power or use power cord as a han-
dle. Always unplug by grabbing the plug and pulling,
do not unplug by pulling the power cord.
• Inspect cord for damage. Do not use damaged cords.
Connect only to properly grounded outlets.
• Keep hair, fingers, loose clothing, and body parts
away from moving parts and openings.
• Turn off all controls before disconnecting machine
• Use caution with ejected liquid or chemicals. High
pressures and temperatures could be hazardous to
nearby people or surroundings.
• Do not run the heater dry. always make sure you have
water
• Do not expose heater to freezing temperatures.
• Prevent burns by wearing gloves or using a barrier to
remove hot quick disconnects.
• Never leave heater or equipment unattended when
connected or powered on.
• The accessory heater was designed for use on 2000JX-
HR/2000KX-HR extractors for carpet, floor and
upholstery extraction applications. Any deviation
from its proper use or purpose and the consequential
damage that may occur is the sole responsibility of
the end user.
ELECTRICAL - 115 Volt
Model: 2000JX-HR/2000KX-HR
This machine is designed to operate on a standard 15
amp, 120 volt, 60 Hz, AC circuit. Voltages below 105 volt
AC or above 125 volts AC could cause serious damage to
the motor.
GROUNDING INSTRUCTIONS FOR
115VOLT:
This piece of equipment must be grounded. Should an
electrical malfunction occur, grounding provides a path
of least resistance for electrical current- reducing the risk
of electric shock. This piece of equipment is furnished
with a cord that has a grounding conductor and ground-
ing plug. The grounded plug must only be plugged
into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordi-
nances.
WARNING:
Connecting the equipment to an improperly grounded
outlet can result in an increased risk of electric shock. A
qualified electrician should be consulted if you are unsure
that the outlet is properly grounded. Do not modify the
plug provided with the equipment. If it will not fit the
outlet, have a proper outlet installed by a qualified electri-
cian.
This appliance is designed for use on a 120-volt circuit.
The grounding plug provided looks like the plug illustrat-
ed in Figure 1. Replace the power cord if the grounding
pin is damaged or broken.
Extension cords connected to this machine should be
12 gauge, three-wire cords with three-prong plugs and
outlets. DO NOT use extension cords more than 25 feet
(7.6 m) long.
Figure 1
4