Table of Contents
Advertisement
en Troubleshooting
Fault
"E:36 / -10"
"E:36 / -25 / -26"
"E:38 / -25 / -26"
lights up.
flashes.
38
Cause and troubleshooting
Remove any unapproved extensions from the water
▶
hose. Connecting the appliance
The pump cap is not fully screwed in.
Ensure that the pump cap is screwed in all the way
▶
into the appliance. The handle on the pump cap
must be in a vertical position.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 33
▶
Drain pump is blocked.
→ "Cleaning the drum", Page 32
▶
if the fault is displayed again,
→ "Cleaning the drain pump", Page 33
▶
Inlet opening of the rubber gasket is blocked.
→ "Cleaning the intake opening in the rubber gas-
▶
ket", Page 36
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
Clean the filters in the water inflow.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 31
▶
Water level is too high.
Start the Άντληση programme.
▶
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Έναρξη/Προσθήκη ρούχων to start the pro-
4.
gramme.
Door is not closed.
Close the door.
1.
Press Έναρξη/Προσθήκη ρούχων to start the pro-
2.
gramme.
Advertisement
Table of Contents
