Advertisement
MODEL: HEATED DISPLAY MERCHANDISER
MODEL CODE : HDM0003
Part
Description
No.
1
INSERT
2
ALLUMINIUM TOP RACK
3
ALLUMINIUM BOTTOM RACK
4
REAR GLASS
5
WATER TANK
6
NON ILLUMINATED ROCKER SWITCH
7
PILOT LIGHT
8
KNOB
9
BEZEL
10
CONTROL FACIA
11
THERMOSTAT
12
FOOT
13
BOTTOM PANEL
14
ELEMENT
15
SIDE GLASS
16
OUTER ENCLOSURE
17
LIGHT BULB
18
FRONT GLASS
7
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical shock.
Do not use equipment if power cord is damaged or has been modified
SAFETY
READ ALL INSTRUCTIONS BEFORE USE. FAILURE TO
FOLLOW THESE PRECAUTIONS COULD RESULT IN INJURY TO
YOURSELF AND OTHERS
1.
When this appliance is to be positioned in close proximity
to a wall, partitions, kitchen furniture, decorative finishes, etc.
it is recommended that they be made of non-combustible
material. If not, they shall be clad with a suitable non-combustible
heat insulating material, and the closest attention be paid to fire
prevention regulations.
2.
Use the appliances on an individual 15A mains outlet only.
DO NOT OVERLOAD THE CIRCUIT.
3.
Ensure that the equipment and the power supply cord does not
come into contact with hot surfaces.
4.
Supervision is necessary when the appliance is used in close
proximity to children.
5.
If the supply cord is damaged, it must be replaced with a new
cord assembly available from the suppliers agent.
6.
Use only earthed outlets matching the serial plate voltage.
7.
Have equipment installed by a qualified personnel in accordance
with local codes and ordinances.
8.
Use equipment in a flat level position.
9.
Do not operate unattended
10. The equipment may be hot, even though the pilot light is not on.
11. Do not operate if equipment has been damaged or is
malfunctioning in any way.
12. These appliances are designed to run only on alternating current
(A.C.) DO NOT CONNECT TO DIRECT CURRENT (D.C)
WARNING
Electric Shock Hazard.
Keep water and other liquids from entering the inside
of the equipment. Liquid inside the equipment could
cause an electrical shock
4
Advertisement
