Table of Contents
Advertisement
WASHING OF THE NEW EQUIPMENT
•
The equipment has already been adjusted at our factory with
light mineral oil left inside the pumping group as protection.
Therefore, wash with diluent before sucking the product.
•
Lift the suction pipe and dip it into the solvent tank.
•
Ensure the gun (F4) is without nozzle.
F4
•
Open the re-circulation tap.
Turn the unit ON-OFF switch (F5) on the "ON" position (I).
•
Rotate the pressure setting knob (F6) slightly clockwise so
that the machine operates at minimum power.
F6
GIOTTO
•
Point the gun at a container keeping the trigger pressed (so
as to drain the oil inside) till a clean solvent comes out. Now,
release the trigger.
•
Remove the suction pipe and take away the solvent tank.
•
Point the gun at the solvent tank and press the trigger so as
to recover the residual solvent.
•
As the pump idles, press the ON/OFF switch (F5) on the
position "OFF" (0) to stop the tooling.
the solvent fumes and the electric motor.
•
Now the machine is ready. Should you use water paints,
besides the solvent wash, a wash with soapy and then clean
water is suggested.
•
Insert the gun trigger lock and assemble the nozzle.
PREPARATION OF THE PAINT
•
Make sure the product is suitable to be used with a spray
gun.
F5
•
Mix and filter the product before using it. For filtration, use
CLOSE-MESH (ref.214) and LARGE-MESH (ref.215) LARIUS
METEX braids.
ON
the product.
Never use products containing halogen hydrocarbons (as
methylene chloride). If these products come into contact with
aluminium parts of the equipment, can provoke dangerous
chemical reactions with risk of explosion.
7
Absolutely avoid to spray solvents indoors. In
addition, it is recommended to keep away from
the pump in order to avoid the contact between
Make sure the product to be used is compatible
with the materials employed for manufacturing
the equipment (stainless steel and aluminium).
Because of that, please contact the supplier of
Advertisement
Table of Contents
