Table of Contents
Advertisement
Galaxian 3D MKII
LASER RADIATION
IS EMITTED FROM
THIS APERTURE
AVOID EXPOSURE
ADJ Products, LLC
6122 S.Eastern Ave.
Los Angeles. CA 90040 USA
Manufactured:
LASER RADIATION AVOID
DIRECT EYE EXPOSURE
Maximum output <5 mW
Wavelength 532nm & 635nm
Class IIIa laser product
This device complies with 21 CFR chapter l,
Subchapter J, CFR 1040.10 and 1040.11
Specification stickers
CAUTI ON - CLASS 3R
LASER RADIATION WHEN OPEN
AVOID DIRECT EYE EXPOSURE
ADJ Products, LLC - www.adj.com - Galaxian 3D MKII Instruction Manual Page 7
Laser Warning Labels
LASER RADIATION
IS EMITTED FROM
THIS APERTURE
AVOID EXPOSURE
40mm
40mm
41 mm
LASER RADIATION AVOID
DIRECT EYE EXPOSURE
Maximum output <5 mW
Wavelength 532nm & 635nm
Class IIIa laser product
This device complies with 21 CFR chapter l,
Subchapter J, CFR 1040.10 and 1040.11
40mm
CAUTI ON - CLASS 3R
LASER RADIATION WHEN OPEN
AVOID DIRECT EYE EXPOSURE
Specification stickers
Galaxian 3D MKII
Power Supply:
Before plugging your unit in, be sure the source volt-
age in your area matches the required voltage for your ADJ Galax-
ian 3D MKII. The ADJ Galaxian 3D MKII voltage is user selectable.
Because line voltage may vary from venue to venue, you should be
sure your unit voltage matches the wall outlet voltage before attempt-
ing to operate you fixture.
DMX-512:
DMX is short for Digital Multiplex. This is a universal pro-
tocol used by most lighting and controller manufactures as a form of
communication between intelligent fixtures and controllers. A DMX
controller sends DMX data instructions from the controller to the fix-
ture. DMX data is sent as serial data that travels from fixture to fixture
via the DATA "IN" and DATA "OUT" XLR terminals located on all DMX
fixtures (most controllers only have a DATA "OUT" terminal).
DMX Linking: DMX is a language allowing all makes and models of
different manufactures to be linked together and operate from a sin-
gle controller, as long as all fixtures and the controller are DMX com-
pliant. To ensure proper DMX data transmission, when using several
DMX fixtures try to use the shortest cable path possible. The order
in which fixtures are connected in a DMX line does not influence the
DMX addressing. For example; a fixture assigned a DMX address of 1
may be placed anywhere in a DMX line, at the beginning, at the end,
or anywhere in the middle. Therefore, the first fixture controlled by the
controller could be the last fixture in the chain. When a fixture is as-
signed a DMX address of 1, the DMX controller knows to send DATA
assigned to address 1 to that unit, no matter where it is located in the
DMX chain.
Data Cable (DMX Cable) Requirements (For DMX and Master/Slave
Operation): The Galaxian 3D MKII can be con-
trolled via DMX-512 protocol. The Galaxian 3D
MKII is a five channel DMX unit. The DMX address
is set electronically using the controls on the top
rear panel of the unit. Your unit and your DMX con-
troller require a approved DMX-512 110 Ohm Data
cable for data input and data output (Figure 1). We
recommend Accu-Cable DMX cables. If you are
making your own cables, be sure to use standard
110-120 Ohm shielded cable (This cable may be purchased at almost
ADJ Products, LLC - www.adj.com - Galaxian 3D MKII Instruction Manual Page 8
Set Up
Figure 1
Advertisement
Table of Contents
