Polaris RANGER EV 2022 Owner's Manual page 52

FEATURES AND CONTROLS
SEAT BELT INSPECTION
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide
smoothly into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage,
including cuts, wear, fraying or stiffness. If any damage is found, or if the seat
belt does not operate properly, have the seat belt system checked and/or
replaced by an authorized dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap
and water. Do not use bleach, dye or household detergents. Rinse the entire
length of the belt webbing. Use a garden hose to flush out the retractor and
latch housings regularly.
CHARGING CORD
The charging cord is located under the hood on the right side of the vehicle. See
page 62 for charging instructions.
AUXILIARY 12-VOLT TERMINAL BOARD
The 12-volt terminal board is located under the hood. It contains constant 12-
volt, switched 12-volt and ground terminals that can be used to power auxiliary
lights and accessories. The terminals are limited to 10 amps.
ROLLOVER PROTECTIVE STRUCTURE (ROPS)
The Rollover Protective Structure (ROPS) on this vehicle meets OSHA®
1928.53 rollover performance requirements. Always have your authorized
dealer thoroughly inspect the ROPS if it ever becomes damaged in any way.
No device can assure occupant protection in the event of a rollover. Always
follow all safe operating practices outlined in this manual to avoid vehicle
rollover.
Vehicle rollover could cause severe injury or death. Always avoid operating in
50
a manner that could result in vehicle rollover.
WARNING