Finding The Beginning Of A Tune - JVC KS-FX490 Instructions Manual

To play back tapes recorded with the
Dolby B NR*
1
Press MODE to enter the functions mode
while listening to a tape.
"MODE" flashes on the upper part of the
display, and the number buttons work as
different function buttons.
2
Press (Dolby B), while "MODE" is still on
the display so that the
lights up.
"DOLBY B" also appears on the display for
several seconds.
To cancel the Dolby B NR, repeat steps 1
and 2 above again.
* Manufactured under license from Dolby
Laboratories.
"Dolby" and the double-D symbol are
trademarks of Dolby Laboratories.
Prohibiting cassette ejection
You can prohibit cassette ejection and lock a
cassette in the cassette compartment.
While pressing TAPE (CD-CH), press and
hold for more than 2 seconds.
TAPE
"NO EJECT" flashes on the display for about 5
seconds, and the cassette is locked and cannot
be ejected.
To cancel the prohibition and unlock the
cassette
While pressing TAPE (CD-CH), press and hold
again for more than 2 seconds.
"EJECT OK" flashes on the display for about
5 seconds, and the cassette is unlocked.
Note:
If you press c while cassette ejection is prohibited,
the cassette will not be ejected.
(Dolby B) indicator

Finding the beginning of a tune

Multi Music Scan allows you to automatically start
playback from the beginning of a specified tune.
You can specify up to 9 tunes ahead of or before
the current tune.
During playback
Specify where (how many tunes ahead of
or before the current tune) the tune you
want is located.
Press ¢
tune ahead of the current
tune on the cassette.
Press 4
tune before the current tune
on the cassette.
Each time you press the buttons, the number
changes up to ±9.
When the beginning of the specified tune is
located, playback starts automatically.
Notes:
• While locating a specified tune:
– If the tape is rewound to its beginning, playback
starts from the beginning of that side.
– If the tape is fast-forwarded to the end, it is
reversed and played from the beginning of the
other side.
• In the following cases, the Multi Music Scan
function may not operate correctly:
– Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions
between tunes.
– Tapes with short non-recorded sections.
– Tapes with high level of noise or humming
between tunes.
– Tapes with tunes recorded at low recording levels.
– The Dolby NR setting does not match. For
example, if Dolby B NR is on and the tape was
recorded with no Dolby NR.
to locate a
to locate a
11