Table of Contents
Advertisement
DECLARATION OF CONFORMITY
We, Santa Barbara Instrument Group, a division of Aplegen, Inc., 147-A
Castilian Drive, Goleta, CA 93117 USA, (805) 571-7244, declare under our
sole responsibility that the Model STF-8300 CCD camera complies with
Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that
may cause undesired operation.
____________________________________________________________
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the receiver and the
equipment.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
A ferrite clip on the USB cable, power cable, and tracker cable must be used
when operating this equipment.
You are also warned that any changes to this certified device will void your
legal right to operate it.
Operating Manual for STF-8300 Series Cameras
Revision 1.2
December 8, 2011
Page i
Advertisement
Table of Contents
