Technics SU-G700M2 Owner's Manual page 20

Operations
Connecting a power amplifier, subwoofer, etc.
You can connect the power amplifier, subwoofer, etc.
with analog audio cable (not supplied) to output the
analog audio signals.
Power amplifier,
Subwoofer, etc.
Do not input the audio signal from PRE
OUT/LINE OUT terminals to the analog
audio input terminals of this unit. Doing so
may cause malfunction.
Using analog audio cable
1 Disconnect the AC power supply cord.
2 Connect this unit and a power
amplifier, subwoofer, etc.
3 Connect the AC power supply cord to
this unit. ( 13)
4 Press [AMP ] to turn this unit on.
Note
• For details, refer to the operating instructions of
the connected device.
• Sound is not output from PRE OUT terminals
when using this unit as main amplifier. ( 18)
Setting the audio output (PRE OUT)
You can set the audio output of the speaker
output terminals and PRE OUT terminals.
1 Press [AMP].
20
(20)
Analog audio cable (not supplied)
2 Press [SETUP].
3 Press [ ], [ ] repeatedly to select
"PRE OUT" and then press [OK].
4 Press [ ], [ ] to select the output
setting and then press [OK].
• The factory default is "Off".
• Not available when using this unit as main
amplifier. ( 18)
On:
Sound is output from the speaker output
terminals and PRE OUT terminals.
On (Speaker:Off):
Sound is not output from the speaker output
terminals. Sound is output from PRE OUT
terminals.
Off:
Sound is not output from PRE OUT terminals.
Sound is output from the speaker output
terminals.
Note
• It is recommended to set to "On (Speaker:Off)"
(rated output: 1 V) when connecting a power
amplifier.
• Set to "Off" when using output correction
function for the connected speakers because
the correction function (LAPC) effects on the
audio output from PRE OUT terminal. ( 24)