3. Side Heat Shields; Brick Layout - England's Stove Works 50-SNC13 Installation & Operation Manual

3. Side Heat Shields

This accessory
comes with the hardware
(six (6) mounting screws)
necessary to install it on
the rear of the stove. This
is a two-piece heat shield,
but is installed one piece at
a time. There are pre-
punched holes on each
side of the Rear Heat
Shield; while holding each
piece of the Side Heat
Shield in place, align the
pre-punched holes in the
Side Heat Shield with the
existing holes in the Rear
Heat Shield, and fasten
with the screws provided.
See Illustration 1 for
clearances with and without
side heat shields.
Illustration 4
1 – 9" x 4" x 1.25" brick (Qty. 11)
3 – 4" x 2.5" x 1.25" brick (Qty. 1)
5 – 4" x 4.5" x 1.25" brick (Qty. 1)
7 – 9" x 2.25" x 1.25" brick (Qty. 2)
item
Side
Heat
Shield
Illustration 3 – Side Heat Shield and Blower Installation

BRICK LAYOUT

Rear Heat Shield
Install AC-16 Optional
Blower on these (4) mounting
holes. See "Optional Blower
Instructions" on page 6 for
instructions.
2 – 9" x 4" x 1.25" brick w/ .75 x .75 notch (Qty. 2)
4 – 4.5" x 4" metal plate (Ash Drawer Plate, Qty. 1)
6 – 9" x 4" x 1.25" brick w/ 1" x 3" notch (Qty. 1)
13
Side
Heat
Shield