Advertisement
SIMPLE™ KEY USER GUIDE
OPTIONAL STEP: ERASE REMOTE
Instructions have timing requirements. If you wait too long between steps, your vehicle's computer may time out,
requiring you to start over. Once you begin the pairing procedure, move at a quick and even pace.
NOTE: This process is only necessary if you received the maximum number of keys error during REMOTE
PAIRING (see FAQs for more information). Once you have completed the steps below, go back to REMOTE
PAIRING.
1.
Find your vehicle's make, model, year, and transponder chip type in the Compatibility Lookup on pages 4-5.
Turn the dial on the EZ Installer™ to the position listed for your vehicle's make, model, year, and transponder
chip type under the column labeled, "Erase Remote EZ Installer™ Dial Position."
a.
NOTE: If more than one dial position exists for your vehicle, try the PRIMARY dial position first. If you are
unable to successfully pair the key, try the ALTERNATE dial position listed for your vehicle.
b. NOTE: One working key and the new key should be present during the pairing process.
2.
Enter the vehicle and ensure all doors are closed.
3.
Begin with the vehicle in PARK and the engine OFF.
4.
Remove the security label from the EZ Installer™ and insert it firmly into the on-board diagnostic (OBD) port
located under the dash.
a.
The location of your vehicle's OBD port can be found in your owner's manual.
12
SIMPLE™ KEY USER GUIDE
5.
Insert the original key, buttons facing down, and turn the ignition to the ON/RUN position. If there are no
markings, turn the key clockwise and stop just short of starting the engine.
a.
NOTE: It is important to make sure that you insert the key, buttons facing down, so that when you
turn the key to the ON/RUN position, buttons are facing up and easily visible and accessible for the
following steps.
TOYOTA IGNITION POSITIONS
6.
To continue, press and release the EZ Installer™ button.
7.
Wait and listen for 2 quick beeps from the EZ Installer™.
8.
On the key in the ignition, simultaneously press the LOCK and UNLOCK buttons on the remote. Then, press and release the
UNLOCK button.
NOTE: All other paired remotes will be erased.
a.
9.
If ERASE REMOTE is successful, you will hear 3 quick beeps from the EZ Installer™. Depending on the model, your vehicle
may also beep twice.
NOTE: If you do not hear beeps from the EZ Installer™ and/or your vehicle, an error may have occurred (see FAQs for
a.
more information). Repeat Step 8 again.
10.
If you need to pair keys, leave the EZ Installer™ plugged into the OBD port and continue to STEP 1 (of 1) KEY PAIRING.
13
Advertisement
