Installing The Turbocharger - ABB TPS 57E01 Operation Manual

Operation Manual / TPS48-D/E.. - TPS61-D/E..
7 Removal and installation / 7.4 Installing the turbocharger

7.4 Installing the turbocharger

© Copyright 2020 . All rights reserved.
Loosen the fixing screws (D) on the bearing casing.
u
Lift the turbocharger from the engine and put it down.
u
Cover oil connections.
u
Remove covers from oil connections.
u
Visually inspect O-ring gaskets of oil supply and drain pipe (O-ring
u
gaskets for engine are not included in the scope of delivery of ABB).
**) When the turbocharger is mounted on the engine support, the bolt
threads and screw heads must be lightly oiled (assumed friction coeffi-
cient µ = 0.12 for tightening torque)
Product Through hole in
bearing casing
[mm]
TPS48 17
TPS52 21
TPS57 21
TPS61 25
Attach lifting gear to bearing casing.
u
If a gas outlet manifold is provided, sling lifting gear around it addi-
u
tionally or fasten it to lifting gear using a swivel lifting eye (C) (see
also section Transport / Weights).
Lift turbocharger, place on bracket and align.
u
Tighten fixing screws (D) to the bearing casing in accordance with the
u
table above.
Fasten all gas, water and air lines in accordance with the engineb-
u
uilder's instructions.
HZTL2410_EN
Thread size Tightening
[mm] torque
[Nm]
M16 230
M20 455
M20 455
M24 780
Rev.F
Strength class
in acc. with
DIN/ISO 898
10.9/12.9
10.9/12.9
10.9/12.9
10.9/12.9
March 2020