Page 1
If you need additional copies of any literature, or if you have questions concerning the safe and proper operation of this tool, contact Victaulic, P.O. Box 31, Easton, PA 18044-0031, Phone: 1-800-PICK VIC, E-Mail: pickvic@victaulic.com.
TM-VAPS112 / Operating and Maintenance Instructions Manual HAZARD IDENTIFICATION OPERATOR SAFETY INSTRUCTIONS Definitions for identifying the various hazard levels are provided below . The VAPS112 Pipe Stand is designed for the sole purpose of supporting pipe to be roll This safety alert symbol indicates grooved .
Page 5
TM-VAPS112 / Operating and Maintenance Instructions Manual DANGER CAUTION Avoid using the pipe stand in potentially The VAPS112 pipe stand is designed dangerous environments. Do not expose ONLY for supporting pipe sizes, materials, the pipe stand to rain, and do not use and wall thicknesses as designated.
TM-VAPS112 / Operating and Maintenance Instructions Manual INTRODUCTION The VAPS112 Pipe Stand supports pipe sizes 3/4 - 12 inches/26 .9 - 323 .9-mm (11/2-foot/0 .5- NOTICE meter to full, single 20-foot/6-meter random lengths) and has a load rating of 1075 pounds/ •...
• Operate the tool only with a safety foot switch. If the tool does not contain a safety foot switch, contact Victaulic. Contact Victaulic with questions regarding the safe and proper operation of tools: Web: victaulic.com E-Mail: pickvic@victaulic.com Phone: 1-800-PICK-VIC 0567 Rev.
TM-VAPS112 / Operating and Maintenance Instructions Manual TOOL AND PIPE STAND SETUP When grooving pipe that is supported with a pipe stand, select a location for the tool and pipe stand by taking into consideration the following factors: Adequate space to handle pipe...
TM-VAPS112 / Operating and Maintenance Instructions Manual 6a. Position the pipe in the pipe stand and onto the roll grooving tool’s lower roll . If using a pipe sling, the sling can be positioned between the ball transfer units when the pipe is positioned on the pipe stand .
1a. Regular lubrication and cleaning is required the height adjusting nut . for the VAPS112 Pipe Stand . On a weekly basis, apply dry graphite to the ball transfer units . Work the dry graphite in by rotating the ball transfer units .
Ball transfer units are clogged or there is a the ball transfers lack of lubrication on the ball transfer units. In the event of tool malfunction outside the scope of the troubleshooting section, contact Victaulic for assistance. UPDATED 09/2021 TM-VAPS112...
Need help?
Do you have a question about the VAPS112 and is the answer not in the manual?
Questions and answers