Page 1
If you need additional copies of any literature, or if you have questions concerning the safe and proper operation of this tool, contact Victaulic, P.O. Box 31, Easton, PA 18044-0031, Phone: 1-800-PICK VIC, E-Mail: pickvic@victaulic.com.
TM-VAPS1672 / Operating and Maintenance Instructions Manual HAZARD IDENTIFICATION OPERATOR SAFETY INSTRUCTIONS Definitions for identifying the various hazard levels are provided below . The VAPS1672 Pipe Stand is designed for the sole purpose of supporting pipe to be roll This safety alert symbol indicates grooved .
Page 5
TM-VAPS1672 / Operating and Maintenance Instructions Manual DANGER CAUTION Avoid using the pipe stand in potentially The VAPS1672 pipe stand is designed dangerous environments. Do not expose ONLY for supporting pipe sizes, materials, the pipe stand to rain, and do not use and wall thicknesses as designated.
TM-VAPS1672 / Operating and Maintenance Instructions Manual INTRODUCTION RECEIVING THE TOOL The VAPS1672 Pipe Stand is shipped NOTICE completely assembled and packaged in a palletized container . Save the original packaging • Drawings and/or pictures in this manual for return shipment of rental tools .
If you need additional copies of any literature, or if you have questions concerning the safe and proper operation of any pipe preparation tools, contact Victaulic, P.O. Box 31, Easton, PA 18044-0031, Phone 1-800-PICK VIC, E-Mail: pickvic@victaulic.com.
TM-VAPS1672 / Operating and Maintenance Instructions Manual TOOL DIMENSIONS AND SPECIFICATIONS 43.8 in/ 1113 mm 36.0 in/ 914 mm 20.0 in/ 508 mm Net pipe stand weight is 480 pounds/218 kilograms . REV_B...
TM-VAPS1672 / Operating and Maintenance Instructions Manual PRE-OPERATION CHECKS AND TOOL AND PIPE STAND SETUP ADJUSTMENTS When grooving pipe that is supported with a pipe stand, select a location for the tool Every Victaulic pipe stand is checked, adjusted, and pipe stand by taking into consideration and tested at the factory prior to shipment .
TM-VAPS1672 / Operating and Maintenance Instructions Manual INITIAL PIPE STAND ADJUSTMENTS CAUTION • This pipe stand must be used ONLY for supporting pipe sizes, materials, and wall thicknesses as designated. Failure to follow this instruction could cause personal injury or damage to the pipe stand.
Page 11
TM-VAPS1672 / Operating and Maintenance Instructions Manual Tighten the hex lock nut completely to Remove the polyethylene wheel from retain the polyethylene wheel . underneath the roller support, as shown above . Repeat steps 2–7 to relocate the other three polyethylene wheels to the new 5a.
TM-VAPS1672 / Operating and Maintenance Instructions Manual RATCHET OPERATION The ratchet has three settings that can be used for raising or lowering the roller support to accommodate various pipe sizes . Place the indicator on the ratchet to the middle location (when viewed from the end of the ratchet) to enable the ratchet to rotate freely .
TM-VAPS1672 / Operating and Maintenance Instructions Manual For final adjustment of the pipe stand, a sample piece of pipe must be test grooved . Roll groove the pipe by referring to the Operating and Maintenance Instructions Manual for the applicable tool being used to roll groove the pipe .
When ordering parts, the following information condition . Replacement parts must be ordered is required for Victaulic to process the order and from Victaulic to ensure proper and safe send the correct part(s) . Parts can be ordered operation of the pipe stand .
Pipe will not stay in roll Pipe is not square cut. grooving tool. Back end of pipe is above level. Roll grooving tool is tilted forward. In the event of tool malfunction outside the scope of the troubleshooting section, contact Victaulic for assistance. REV_B...
Need help?
Do you have a question about the VAPS1672 and is the answer not in the manual?
Questions and answers