Troubleshooting - Electrolux EGT7355 User Manual

Hide thumbs Also See for EGT7355:
Table of Contents

Advertisement

12
www.electrolux.com
moist cloth and non-abrasive
detergent. After cleaning, wipe the
hob dry with a soft cloth.
• To clean the enamelled parts, cap
and crown, wash them with warm
soapy water and dry them carefully
before you put them back on.
6.5 Cleaning of the Vertical
Burner
The crowns of brass burners can darken
after long use. To remove the dark
marks, do as follows:
1. Prepare a mixture of 50% water and
50% wine vinegar.
2. Soak the crowns in the mixture for no
longer than 10 minutes. Remove the
marks with a sponge. A high
concentration of moisture or

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
There is no spark when
you try to activate the
spark generator.
The flame extinguishes im‐
mediately after ignition.
The flame ring is uneven.
3. Rinse the crowns in water to remove
6.6 Cleaning the spark plug
This feature is obtained through a
ceramic ignition candle with a metal
electrode. Keep these components well
clean to prevent difficult lighting and
check that the burner crown holes are
not obstructed.
6.7 Periodic maintenance
Speak to your local Authorised Service
Centre periodically to check the
conditions of the gas supply pipe and the
pressure adjuster, if fitted.
Possible cause
The hob is not connected
to an electrical supply or it
is connected incorrectly.
The fuse is blown.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heat‐
ed up sufficiently.
Burner crown is blocked
with food residues.
immersion of the burners in water for
too long can cause damage to their
surfaces.
the mixture and dry them carefully.
Remedy
Check if the hob is correct‐
ly connected to the electri‐
cal supply.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Place the burner cap and
crown correctly.
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec‐
onds.
Make sure that the injector
is not blocked and the
burner crown is clean.

Advertisement

Table of Contents
loading

Table of Contents